BETAFPV Air65 Brushless Whoop Quadcopter, Ultralight 1S 65mm Micro Whoop Drone with C03 FPV Camera, G473 5IN1 Air Brushless FC 0702SE Ⅱ 27000KV Motors for FPV Racing Indoor & Outdoor- ELRS V3

Ultralight Racing Whoop: Weighing in at just 17.3g, equipped with Air canopy, Air65 brushless whoop frame, 5IN1 Air brushless flight controller, ultra-lightweight feature. Pilots will get a new level of lightweight Racing flying experience in this Air65 1S 65mm tiny whoop
5IN1 Air Brushless FC: The new 5IN1 Air brushless flight controller uses the G473 processor which has superior computing power and is equipped with an ICM42688P gyroscope, delivers an impressive thrust t-to-weight ratio of 5.82:1— boosts alongside a 12.7% increase in propulsion efficiency, setting a new standard in performance. It also integrated FC, ESC, OSD, RX, and Onboard 5.8 25~400 VTX, weighing only 3.6g
Default Protocol & Firmware: Air65 bruhsless drone comes with the default protocol is ELRS, and the firmware version is V3, please confirm the controller or the TX module connect with this drone have the some protocol and the some firmware version so that they can bind together. If there has any issues that the drone out of bind with the controller, please calibrate the drone and re-bind with the controller again
VTX & Signal: Air65 Brushless Drone comes with a C03 FPV Micro camera weighs only 1.45g, and the flight controller has the onboard VTX which can adjust the power from 25-400mW, and please note higher VTX power consumes more energy and generates more heat, reducing flight time. It is recommended that pilots use 25~100 for daily indoor flight to obtain better flight time
Racing Propulsion Systems: Racing Version focuses on high-speed and high-agility flight, utilizing the 0702SE Ⅱ 27000KV brushless motors and GF 1219S 3-blade propellers for incredible speed bursts and agile steering. Any issues with the motor or doesn’t work, please recalibrate the drone first
Motor Spin: After a few time use, the date of the motor may offset and need to re-calibrate the drone, please follow the step on the manual to re-calibrate the drone and re-bind with the transmitter
[amz_corss_sell asin=”B0DQPMZ3WB”]